(2)
Operation of reading key data
When press the [Read] button, the
screen will display “RE”, that means the device is in
the condition of inducting and
reading the
data. Otherwise it will display “ER”(Error). You
should to repeat the operation, until “RE” appears.
Put a key
need to be matched close to the device, the device
begins to induct and read the key’s data. When your
hear “DI” for
3 times and “OK” appears on the screen, the read of
key’s data has been finished. Otherwise the
operation is
failed. You should follow step1and step 2 to redo
again.
(3)
Operation of
reading in the Data
Dissemble the
memory chip from ECU, clean it and put it into the
chip clamp. Then put the chip clamp on the
programmer’s
lock holder and lock it. As the right picture show.
This device
is suitable for TOYOTA Series. Firstly according to
your car’s type, then press the [MODE] button to
choose
suitable
pattern. There are 4 kinds of pattern for you to
choose, including “56”, “T1”, “T2”and “86”. If your
car is
TOYOTA CAMRY,
you should choose pattern “56”, it will tell you the
corresponding chip of your car is 93C56, you should
dissemble it
from the position of IC601 of the ECU; If the type of
vehicle is TOYOTA (4700, AVALON, or LEXUS), you
should choose
pattern “T1” and dissemble chip 93C56 from the
position of IC900 of the ECU; If the type of vehicle
is
TOYOTA (USA)\
(EUROPEAN) 4700 and LEXUS 400, you should choose
pattern “T2”. But because these two kinds of
vehicle have
anti-theft computer and there’s no memory chip in the
ECU, that you should only dissemble the chip
93C66 of
anti-theft computer directly; As the same, if the
type of the vehicle is new style PREVIA, you should
choose
pattern “86”
and dissemble chip 93C86 from the position of IC900
of ECU. Patterns will be displayed on the screen like
the following picture:
Press the
[PROGRAM] button to make device read in the inducted
key’s code into the ECU. During the data has been
reading in, the screen would glitter and display “WR”.
When
the data has
been read in the ECU, “OK” will appear on the screen
and your will hear a sound “DI” once. Otherwise the
operation is failed. Please to check the reasons! The
possible
reason is: chip has been put in the wrong position,
chip hasn’t been clipped or choose unsuitable pattern
After the
writing of date, the chip should be put back into the
ECU.
The matching of key has been finished. And the new
key can be used to start the vehicle.
(4)
Copy Auto
key:
TOYOTA key
adapter can be used to copy 3 keys at the same time.
You should need to repeat the step1 and step 2 of
[Operation of reading key data].
Device
supports on direct current 12V-15V. Please make sure
the power off when the device hasn’t been used.
(5)
Notice:
This function will cancel all the legit key code.
You should do the synchronous matching program during
all
the Auto keys (including new matching keys) and
Engine Control Unit or Anti-theft Machine Control
Unit.
If the user lost a legit key, you must make all the
legit keys to be refinished the key matching program
in safe. This operation can make the losing legit key
invalidate.
