Toy-Pro Device
With this OBD by-pass adaptor , you can
program till year 2008 all type of Toyota / Lexus 4D
transponder key in less than a minute
·
The operating
step as follows: ( read the using step and the importance
notice carefully)
1. Turn the ignition on with the right 4D chip key.
2.
Connect the programmer to the OBD port of the car, there
are some short beep sounds after power on. When the
connection with the Computer of car is done successfully,
there is a long beep sound in 3 seconds, and the “LED” is
on, as well as the anti-light “SEC”, which means the car
is in the “key programming state”.
3.
Take away the programmer from OBD.
4.一,
Matches 2 pcs main key and 1 pc vice-key to the IMMO computer
（
Notice: 2 new main key and 1 vice-key are needed to close
the programming procedure）
a) Close all the car door.
b)
Insert the first new main key to the ignition for 5
seconds.
c)
Insert the other main key to the ignition for 5 seconds.
d)
Insert the vice-key to the ignition for 5 seconds.
e)
The new ignition key will be confirmed by the new IMMO.
二，Only
program 1 or 3 main keys to the IMMO computer( Manual
close the mode after complete the programming)
a)
Close all the car doors.
b)
Insert the new key for 5 seconds.
c)
Insert another new key for 5 seconds.
d)
Take
out the key from ignition
e)
Insert the first programmed main key, and turn on the
ignition for 5 times quickly, then take it out.
f)
The
new ignition key will be confirmed by IMMO
Notice:
1,
Must
use the right Toyota 4D chip, otherwise you take the
consequences.
2,
Don’t try to open the cover of programmer and dash board
3,
This
machine is only provided for the legal auto repair.
Otherwise you
will take the above consequences.
