Back Next Locksmith tools Backrest Ordering & Euquiring

                           

Model : Tya-TC1           Key + Remote + Transponder                     Model : Tya-R1              Key + Remote w/o Transponder

For Toyota ( Camry , Corolla Altis , Vios  ,Solemio)

Instruction of programming transponder key

For programming master key

(1) Insert the original master key to start position without starting the engine.

(2) Press the accelerator pedal 5 times within 15 sec.

(3) Press the brake pedal 6 times within 15 sec.

(4) Take out the original key and inset new keys and turn the new key to start position without starting engine within 10 sec.

(5) Press the accelerator pedal 1 time.

(6) LED light now flashes.

(7) Wait for around 60 sec. till the LED light goes out. The key has been set up into the car computer.

(8) Insert another new key if more than one key is needed.

(9) Press the brake pedal to stop on board programming mode.

For programming valet key

(1) Insert the original master key to start position without starting the engine.

(2) Press the accelerator pedal 4 times within 15 sec.

(3) Press the brake pedal 5 times within 15 sec.

(4) Take out the original key and inset new keys and turn the new key to start position without starting engine within 10 sec.

(5) Press the accelerator pedal 1 time.

(6) LED light now flashes.

(7) Wait for around 60 sec. till the LED light goes out. The key has been set up into the car computer.

(8) Insert another new key if more than one key is needed.

(9) Press the brake pedal to stop on board programming mode.

 

Instructions of programming remote control

For programming remote control

(1) Deactivate the car security system.

(2) Open any one door.

(3) Insert key into ignition and turn 5 times (on – off position and stop on off position) within 10 seconds. LED light is on.

(4) Press any key on the new remote control within 16 seconds, now LED goes off. Then press the same key on the remote control. LED is on again. Now the remote control programming procedures has been completed

(5) For programming second remote control, repeat step 4 within 16 seconds. (You have to do the 4th step for the original remote control also because when starting learning mode all the memory of remote in the computer is deleted).

(6) To stop the learning mode, just close the door, turn on the ignition, or send no signal from any remote control within 16 seconds. The LED will stop flash after learning mode stops.

(7) The car computer can store up to 6 remote controls.

                                                               

                                                               My transponder remote key is for new type remote control.

 

Old Type  -  New Type